Paper Info
Title
Analysis Of The Integrated Sepic-Flyback Converter As A Single-Stage Single-Switch Power-Factor-Correction Led Driver
Abstract
This paper proposes a new isolated single-stage single-switch power-factor-correction (S4 PFC) driver for supplying light-emitting diodes (LEDs) without electrolytic capacitor. In the proposed LED driver, the switch turns on under zero current switching (ZCS) condition. Also, it turns on at a voltage less than its nominal voltage stress, and therefore, the switch capacitive turn-on loss decreases too much extent. The leakage energy is absorbed, so there are no voltage spikes across the switch when the switch turns off. In this paper, operating principles of the proposed driver are discussed, and design considerations are presented. Also, a laboratory prototype for supplying a 21 W/30 V LED module from 220 Vrms/50 Hz ac mains is implemented, and experimental results are presented to verify the theoretical analysis.
Year
DOI
Venue
2016
10.1109/TIE.2016.2523457
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS
Keywords
Field
DocType
Integrated single-ended primary inductor converter (SEPIC)-flyback converter, light-emitting diode (LED) driver, power-factor correction (PFC), single stage, single switch
Voltage spike,Electrolytic capacitor,Capacitor,Flyback converter,Voltage,Power factor,Inductor,AC power,Control engineering,Engineering,Electrical engineering
Journal
Volume
Issue
ISSN
63
6
0278-0046
Citations 
PageRank 
References 
15
0.98
6
Authors
2
Name
Order
Citations
PageRank
Behzad Poorali1273.23
Ehsan Adib26013.85