Name
Abstract | ||
|---|---|---|
The measurement of geometric deviations within large-size products is a challenging topic. One of the most applied technique compares the nominal product with the digitalization of real product obtained by a reverse engineering process. Digitalization of big geometric models is usually performed by means of multiple acquisitions from different scanning locations. Therefore, digitalization needs to correctly place the acquired point clouds in 3D digital environment. For this purpose, it is very important identifying the exact scanning location in order to correctly realign point clouds and generate an accurate 3D CAD model.The present paper faces the locating problem of a handling device for reverse engineering scanning systems. It proposes a locating method by using sensor data fusion based on Kalman filter, implemented in Matlab environment by using a low-cost equipment. |
Year | DOI | Venue |
|---|---|---|
2019 | 10.1109/METROI4.2019.8792864 | 2019 II Workshop on Metrology for Industry 4.0 and IoT (MetroInd4.0&IoT) |
Keywords | DocType | ISBN |
Kalman filter,Position measurement,Product design,Prototypes,Reverse Engineering,Sensor data fusion | Conference | 978-1-7281-0430-0 |
Citations | PageRank | References |
0 | 0.34 | 1 |
Authors | ||
4 | ||
Name | Order | Citations | PageRank |
|---|---|---|---|
| Andrea Rega | 1 | 0 | 0.34 |
| Stanislao Patalano | 2 | 17 | 5.02 |
| Ferdinando Vitolo | 3 | 0 | 0.68 |
| Salvatore Gerbino | 4 | 1 | 1.45 |